Recently I faced one
strange transport issue. I developed a new data flow related to newly created
source system. That source system had complete setup from basis point of view
in target BW system as well. It correctly appeared under Source Systems area in
Modeling of TA RSA1. Even Check connection functionality (available
at right click on source system name) worked for the new source system in the
target system. However my transport with had the flow using the source system (so
called “source system dependent objects”) failed with following errors:
Transformation
0G2M3XTZUMRNTOQTV4EH6PK6VGDNVHLD inactive; action cannot be executed Message No. RSBK260
Saving
Objects with Type Data Transfer Process
Saving
Data Transfer Process DTP_00O2SPBAQDZQZ6KPQH9N4U2NT
Transformation
0G2M3XTZUMRNTOQTV4EH6PK6VGDNVHLD inactive; action cannot be executed
Error
while saving Data Transfer Process DTP_00O2SPBAQDZQZ6KPQH9N4U2NT
End
of after import methode RS_DTPA_AFTER_IMPORT (Activation mode) - runtime: 00:00:00
As per error I checked
TRFN and DTP but they both were fine. I also reactivated the TRFN via report RSDG_TRFN_ACTIVATE
but error was still there. I even checked corresponding entries in table RSTRAN
and active version was there.
Then I finally got an idea
to check table RSLOGSYSMAP. This
table contains mapping entries of logical systems. It is used while import phase
of transport takes in place. If there is a BW object related to source sys (e.g.
datasource) in the transport the table is used to map source system in source BW
system to target source system in target BW system. If the source mapping is
not maintained then the transport fails as in my case. The problem is that from
the error which is shown in the transport log it is not possible to find out this
root cause. Notice that the table RSLOGSYSMAP must have the entries for the
system conversion in target BW system(s) of the transport.
- Update 2019/06/14 –
Just want to add precise
error message related to this as it appears in transport log:
No mapping in RSLOGSYSMAP for source
system XXX
Message No. RSDS401
See official SAP docs here.
2 comments:
Thanks for taking time to post this. This helped me twice in the past years! Googled the problem and your solution was right there!
Thanks a lot for the post. It helped me resolve my issue.
Post a Comment